After starting, the machine begins pumping water, but the wash cycle doesn't begin, and the SE error code appears on the display. If you try other programs, you'll see that the drum doesn't rotate in any of them (spin, wash, or rinse).
Error Code 5E or SE: LG Washing Machine
This error is not uncommon for LG brand machines:
- with a silent three-phase motor and belt drive;
- with (Direct Drive) – direct drive.
Sometimes, due to some similarity between the “5” and “S” signs, car owners define this error as 5E.
SE Error – Decoding
The SE icon appears on the screen to indicate that there is a fault in the machine's motor. the drum doesn't spin, because its engine shaft does not rotate and the motor does not work.
Despite such a serious interpretation, the cause of the malfunction isn't necessarily the engine. It's quite possible that it originated in another component. The SE designation only indicates that the motor shaft isn't rotating, but doesn't explain the specific cause. In some cases, the problem may be trivial and easily fixable on your own.
SE error – can you fix it yourself?
-
LJ and fixing the Se error There may be a malfunction in the control electronic module. You can try unplugging the appliance for fifteen minutes and then plugging it back in. LG car again.
- You should check the quality of the connections on the wires leading from the engine to the control board, as well as all connections within the engine itself. Sometimes, some contacts become slightly loose, and reattaching them will correct the problem.
If you have tried all possible options, but the error reappears with each process, then you cannot fix it on your own.
You'll have to contact a repair service for help.
List of faults requiring professional intervention
The table below describes the most common faults that can cause an automatic machine to display the SE error. It was compiled using the experience of workshop specialists.
| Characteristic signs of an error | Possible reasons for the error | Necessary measures | Price of work (parts and labor) |
| The LG washing machine does not start the washing process, the drum does not rotate, and the machine displays error 5E. | Most often, the cause of the malfunction lies in the Hall sensor (also known as the tachogenerator or tachosensor), which monitors the rotational speed. 90% of all malfunctions are caused by this very reason. | The Hall sensor is usually beyond repair and therefore requires replacement. However, occasionally, it may be the resistor in the same circuit as the sensor that burns out, rather than the sensor itself. In such cases, the faulty resistor is replaced. | From 3,500 to 4,600 rubles |
| The machine shows an error, and the washing machine does not spin the drum. | The electronic controller, or simply control module, has failed. This microcircuit is the main one for the machine: it controls the entire unit. | Typically, this control unit can be repaired. It will require replacing damaged or burnt-out components and re-soldering faulty circuits. In some cases, the controller itself will need to be replaced. | Replacement 5600 – 6600 rubles Repair 3100 – 4100
|
| The device constantly displays the SE error code on the display, which does not disappear when adjusting the controls. | The unit's engine has failed. | The faulty engine needs to be replaced. | 7,000 rubles |
| From time to time the device shows error 5E and the drum stops rotating. | The wiring connecting the washing machine's motor to the control unit may be worn out. During washing, the machine vibrates slightly, which can cause the contact to become loose. This is followed by a stop and an error message. | The entire wire harness should be replaced, or the connection of worn wires should be adjusted. | From 1600 to 3000 rubles |
The repair cost shown in the table is made up of the cost of components and the technician's labor. The final price is determined upon completion. professional diagnostics by a "Repair Service" employee, and also depends on the model of the unit.
If you are unable to fix the specified SE error on your own?
To get your unit back up and running again, you can contact a professional repair service.
