We recommend trusting a professional; submit a repair request:
The pump filter is a vital part of the washing machine, acting as a barrier against contaminants and thus naturally extending its lifespan. It's located near the bottom of the washing machine and hidden behind a small door, where you can remove the filter yourself and clean it. If this helps, you won't have to worry about it. repairs will be needed.
How often should I clean my washing machine?
Most people don't even have a clue that it needs to be cleaned from time to time from accumulated dirt every month, as a result of this the pump breaks down The washing machine is leaking. This can be done using three different access methods:
1. Some machines don't have a filter built into the unit. In this case, you'll need to access the pump and its pipes from the center of the washing machine and clean out the clogged area.
2. The filter can be hidden behind a small hatch door, which is closed very tightly and can be opened simply by hand or something thin; it can be removed by unscrewing it counterclockwise.
3. Behind the rectangular panel, it is attached with either rotating hooks or latches. In the first case, the hooks must be turned to a horizontal position; in the second case, the latches must be slowly and carefully bent back, disengaging them. In some washing machine models, the latches are disengaged by sliding them sideways. The filter is removed in the same manner.
The washing machine won't spin out
Sometimes it happens that the filter, in addition to the mounting thread, is additionally attached with a locking screw. This needs to be unscrewed first, and only then should the filter itself be removed. If this procedure hasn't been done in a while, unscrewing it may be very difficult. Control the force to avoid damaging the filter itself. If the filter is very tight, it's best to access it from the pump and hoses.
If there's scale on the threads, removing it isn't easy. You'll need to remove the entire filter assembly and the "snail" and use improvised tools to pry it out of its seat to install the new filter, or you'll need to replace it along with the snail assembly.
To clean, tilt the washing machine back and place a flat container under the hatch. Carefully unscrew the filter, little by little. drain the water, then take it out completely and free it from any debris.
Some dirt may remain in the filter hole. This can be detected by shining a flashlight into the hole. This should be cleaned, then the filter should be returned to its original position and the washing machine tested in drain mode.
The dirtiest and most clogged filters may not come out. In such a situation, you may have to access it from the middle, after which you'll need to replace the pump at an affordable price.
Cheaper washing machines don't have a pump filter. To clear blockages, you have to remove the entire wall of the washing machine to access and clean the filter.
Is the filter clean? But the machine still won't drain?
