Is the water level in your washing machine low?
When choosing a washing machine, many people today pay special attention to the washing class, i.e., the efficiency and cost-effectiveness of the appliance. The priority washing machines, that consume fewer resources such as water and electricity.
One of the main resources consumed by a washing machine is water, since all cycles of the machine are aimed at using this resource.
Water level sensor
Water level in the washing machine – one of the key parameters, the calculation of which allows the machine to start the wash cycle without interruption. The amount of water supplied for washing is controlled by a level switch. This sensor is active throughout the entire wash cycle, monitoring the water level in the washing machine throughout the wash and rinse cycles.
Too much water is being collected
If you see that the water level in the washing machine is higher than normal, this indicates the presence of malfunctions, These include: a broken water inlet valve, a broken pressure switch (level sensor), improper installation of the machine, and a low drain hose connection, etc.
Troubleshooting
- Incorrect installation. First, check that the machine is installed and connected correctly. The required height for attaching the drain hose is specified in the instructions. If drain If the tank is attached too low, the water level in the washing machine will be below normal, as water will simply flow out of the tank into the drain, and the machine will constantly fill with water.
- The drain valve is faulty. A faulty drain valve is indicated by water leaking into the machine even when the door is open and even when the machine is turned off. In this case, water leaks into the tank because the valve can't handle the pressure in the water pipes.
Sometimes this happens due to a broken valve, sometimes due to a simple blockage. Replacing the valve is a simple procedure. the technician will replace the part In a matter of minutes. Before the technician arrives, it's important to turn off the valve on the pipe that connects the washing machine. Otherwise, water will gradually fill the tank and start flooding the room.
Weak water pressure. If the water pressure in the system is low, the water level in the washing machine rises too slowly. In this case, the electronic module may display an error. Problems with no water or low water pressure should be addressed by the building management and maintenance company. However, before calling the housing office, check that the water supply to the apartment isn't shut off or that the valve on the pipe isn't open.
- Defective level sensor. If water continues to fill the washing machine's drum even though the water level is already high, the level switch is malfunctioning. Checking the sensor and replacing it if necessary will help. repairman.
Monitor the water level in your washing machine – this will help you spot the problem and resolve it in time.
